Craft Edge

Adding Glitter fill to word
Page 1 of 1

Author:  dmonica [ Thu Aug 30, 2018 8:48 am ]
Post subject:  Adding Glitter fill to word

I bought a digital paper pack in glitter print. I am trying to add that print to fill a word and its not working. Previously i have done this using the front/back minus front/back. But its losing the glitter print when i do this. can anyone offer any help? i would definitely appreciate it.

i am using the 5 pro.

Author:  SandyMcC [ Fri Aug 31, 2018 9:12 am ]
Post subject:  Re: Adding Glitter fill to word

Use the new Object>Clip Path function in SCAL5. Arrange your word over the glitter graphic you imported. Then move the word to a lower layer so that is below the glitter layer. Select both and go to Object>Clip Path>Set Clip Path. For more details, refer to Secton 7.07 at this link:

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group