How to permanently "merge" to files?

Tips, Tricks and Tutorials for using Sure Cuts A Lot
Post Reply
MichelleHuisamen
Posts: 2
Joined: Tue Jul 17, 2018 12:21 am

How to permanently "merge" to files?

Post by MichelleHuisamen »

Hi, to all...
I'm new in the Silver Bullet Cutter family as in the Sure Cuts Allot program. I want to merg (I do not think merge is the wright term) these 2 images at this point so that when I cut it, it cuts as 1...
Hope you can understand what I want to do, and I also hope someone can help me please, TIA*
Attachments
Screen Shot 2018-07-17 at 10.29.50.png
Screen Shot 2018-07-17 at 10.29.50.png (54.82 KiB) Viewed 3871 times
SandyMcC
Posts: 1114
Joined: Mon May 09, 2011 7:01 am

Re: How to permanently "merge" to files?

Post by SandyMcC »

I assume you plan to move them so that they overlap? If that's a correct assumption, then there are two ways to remove that overlap so that they end up cutting as one shape:

(1) Select both shapes and apply Path>Union

(2) Select both shapes and, on the Style Panel on the right, mark the Weld option. The same result applies but on the screen the two shapes will remain as individual shapes.
Sandy McCauley
Owner of http://www.iloveknk.com/
MichelleHuisamen
Posts: 2
Joined: Tue Jul 17, 2018 12:21 am

Re: How to permanently "merge" to files?

Post by MichelleHuisamen »

I cannot thank you enough, I over looked the Union option the whole time :mrgreen: , never registered the tiny picture. Here is the end result, thanks again*
Attachments
Screen Shot 2018-07-18 at 09.12.37.png
Screen Shot 2018-07-18 at 09.12.37.png (656.45 KiB) Viewed 3857 times
SandyMcC
Posts: 1114
Joined: Mon May 09, 2011 7:01 am

Re: How to permanently "merge" to files?

Post by SandyMcC »

That's adorable! And you're most welcome. :)
Sandy McCauley
Owner of http://www.iloveknk.com/
Post Reply