Craft Edge

Sure Cuts A Lot Forum
It is currently Tue Jun 27, 2017 11:17 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Orientation of cut
PostPosted: Wed Dec 30, 2015 10:39 pm 

Joined: Wed Dec 30, 2015 10:32 pm
Posts: 1
Hi, I have Windows 10, a Roland GX-24 and SCAL V4. When I place an image on the mat, 12x12, it doesn't cut in the place that I put the image. You have to have the image on the bottom half of the mat, if you have it in the top half of the mat it wont cut, and when it cuts the image it is in the opposite place to where it should be and rotates 90 degrees. I have changed the orientation but it doesn't make a difference. Very confused! Any help would be appreciated. thanks


Top
 Profile  
 
 Post subject: Re: Orientation of cut
PostPosted: Sat Jan 02, 2016 1:01 am 

Joined: Sun Jul 22, 2012 2:54 am
Posts: 124
Location: Wandsworth, London
HI there
Little confused by your post - what is your scal set to cut as WISIWIG OR ORIGIN POINT OR CENTRAL ?? If it is set to Origin point it should start cutting from the right hand corner point of the design no matter where the object is set on the mat !

Look carefully at the cutting dialog box - the image in there will show you where SCAL thinks it is about to cut the object

Test it out - if it doesn't work post a snap shot of your cutting dialog box before you send it to cut which might help work out what is going on
regards
Pandora

_________________
Win7, SCAL3.044, Silver Bullet 18" Craft Artist Pro, Photoshop,


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group