Hello,
I am looking for instructions for making a 3-D cone shape that can be cut, assembled and filled. I need to make it approx. 5-6" tall.
Thank you so much!
Julie
3-D cone
Re: 3-D cone
I made it to fit on a 8 1/2 X 11 sheet.
It has a 1/4 inch glue tab.
4 5/8 diameter -- 5 3/4 tall.
You will need to position it within a 1/4 (.250) of the top of the sheet, It is 6 3/16 wide so the sideway position is not critical.
.
Enjoy
It has a 1/4 inch glue tab.
4 5/8 diameter -- 5 3/4 tall.
You will need to position it within a 1/4 (.250) of the top of the sheet, It is 6 3/16 wide so the sideway position is not critical.
.
Enjoy
Bob
My current fun/challenge is glue-less 3D interlocking "structures". BTW --- I am CLUELESS
My current fun/challenge is glue-less 3D interlocking "structures". BTW --- I am CLUELESS
-
mitsim
- Posts: 462
- Joined: Sat Nov 26, 2011 1:32 pm
- Location: SoCal (Windows 7, Eclips1, ECAL 1.500, Photoshop, Illustrator
Re: 3-D cone
Here are a couple of freebies you can take a look at. One is a party hat, which could be inverted. Anyway, can't hurt to take a peek, since they are both freebies.
http://svgcuts.com/blog/2012/10/20/chri ... -svg-free/
http://svgcuts.com/blog/2011/02/15/free ... party-hat/
Good luck!
http://svgcuts.com/blog/2012/10/20/chri ... -svg-free/
http://svgcuts.com/blog/2011/02/15/free ... party-hat/
Good luck!