Craft Edge
http://forum.surecutsalot.com/

Help with downloaded files
http://forum.surecutsalot.com/viewtopic.php?f=17&t=38943
Page 1 of 1

Author:  Terry Lynn [ Sat Nov 30, 2013 8:11 pm ]
Post subject:  Help with downloaded files

I downloaded a file from iStock that is a jpg and an Ai file. I tried to convert it to a svg in Inkscape but my Sure Cuts A Lot still won't load it. It says there is no vector file associated with it. Can anyone help me? I have been trying for over 6 hours now.

Author:  papasue [ Sat Nov 30, 2013 8:26 pm ]
Post subject:  Re: Help with downloaded files

Terry, did you try tracing the jpg file in Inkscape or scal?

When you tried to convert the AI file did you do a save as an svg in ink save not an .ai file?

What version of SCAL are you using since I can open and save as any AI file and then open in eCAL/scal3.

Author:  www.altivar31.ru [ Fri Oct 11, 2019 4:28 pm ]
Post subject:  Help with downloaded files

so I installed the software but I dont see what I am expecting to see

it says .. PLCSIM - thats not the portal?

and when I click it , just shows a little box with a power button and
run, stop etc ..

I want the portal running.. can anyone help out

thanks

Author:  SandyMcC [ Sat Oct 12, 2019 5:45 am ]
Post subject:  Re: Help with downloaded files

What software are you referencing? What version did you install? PC or Mac? And finally, can you post a screenshot of what you're seeing?

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/