Page 15 of 17

Re: Important Announcement: SCAL 1 and 2

Posted: Sun Dec 02, 2012 12:50 pm
by mariehale1021
ok I have scal 2 and want to upgrade to scal3 and i saw somewhere it is free to upgrade -BUT if i upfrade will scal 2 no longer work?

Re: Important Announcement: SCAL 1 and 2

Posted: Sun Dec 02, 2012 2:11 pm
by gj1

Re: Important Announcement: SCAL 1 and 2

Posted: Thu Apr 18, 2013 10:49 pm
by shazzy103
I wish I had seen this before getting rid of my old computer ... I am so upset I have lost the scal software and the new one don't work with the cricut, if I had have known I would have saved the scal file before dumping the old computer

Re: Important Announcement: SCAL 1 and 2

Posted: Fri May 10, 2013 8:06 am
by Crazygurl
Is there any way I can put my firmware version back to its original state on my cricut personal? I updated my firmware and its v1.45 and my scal2 wont work in it?Thanks in advance.

Re: Important Announcement: SCAL 1 and 2

Posted: Fri Jul 19, 2013 8:43 pm
by lilminney
Sad sad sad but thanks for the announcement. I'm wondering if it needs to be reinstalled about activation?

Re: Important Announcement: SCAL 1 and 2

Posted: Fri Nov 08, 2013 1:46 pm
by adrianwfar
I did the firmware update, so how could I go back again! :oops: Thanks
Also, I see the Scal doesn't have a cricut in cutters.

Re: Important Announcement: SCAL 1 and 2

Posted: Fri Nov 08, 2013 6:32 pm
by Sweetness4713
After provocraft threatened lawsuits craftedge no longer support past scal2 for cricut.

Re: Important Announcement: SCAL 1 and 2

Posted: Sat Jun 21, 2014 1:26 pm
by rmmahrens
Crazygurl wrote:Is there any way I can put my firmware version back to its original state on my cricut personal? I updated my firmware and its v1.45 and my scal2 wont work in it?Thanks in advance.
Did you figure out a way to bring the firmware back? I'm also looking to do this.

Re: Important Announcement: SCAL 1 and 2

Posted: Sun Jun 22, 2014 5:25 am
by papasue
I think your only recourse is to contact Provocraft support to see if the will help you downgrade the firmware. Ensure that you understand what the downgrade will do to others programs you have from them.

Provocraft.com

Re: Important Announcement: SCAL 1 and 2

Posted: Mon Jun 23, 2014 4:48 am
by talanhart
There is a way to reverse your firmware back to an older version. It involves replacing one file in the updater program. I have the instructions here on the board. It will take awhile to find, but it can be done.