Help learning how to...
Help learning how to...
I'm wondering if anyone can help me learn how to "curve" or "bend" a round image so that I can cut it from vinyl and it will fit on a round ornament. I have tried and tried but am not having much luck. I know how to use the bend feature but it would seem that the image needs to bend at the top, middle and bottom instead of just in the middle? Thanks for any suggestions
Last edited by cayde on Sun May 15, 2011 7:02 am, edited 1 time in total.
Re: Help learning how to...
Susan E
http://creationsbypapasue.blogspot.com
LEARN, GROW, CREATE, SHARE
Mac 10.12.6 Sierra, eCAL 1.506, ECAL2.023, SCAL4Pro, Export Plug-in, Inkscape 48, iPad/scal3
eClips2.
http://creationsbypapasue.blogspot.com
LEARN, GROW, CREATE, SHARE
Mac 10.12.6 Sierra, eCAL 1.506, ECAL2.023, SCAL4Pro, Export Plug-in, Inkscape 48, iPad/scal3
eClips2.
Re: Help learning how to...
Thanks for the reply, I don't think I asked my question clearly. I have a 3 1/2" round ball (christmas ornament), I am cutting a 2" image from vinyl and trying to attach it to the ornament, but because of the curve of the ornament the vinyl will not lay flat. So I am wondering if I somehow need to "curve" the image to match the curve of the ornament?
Thanks again for your reply, very good video!
Thanks again for your reply, very good video!