Craft Edge

I am trying to convert a pdf file to an svg for a business in town. They need me to cut their logo to put on hard hats. THIS IS A SUPER RUSH. I tried to convert and can't seem to get it done. I now was trying to attach their logo file and see if someone can help me and it says the extension pdf is not allowed. What am I doing wrong? I really need help with getting this converted so I can cut one of these today to show them tonight.

Check yor PM's

I sent it back to you via email already - check your email

Jennifer:

I never received it. Boy am I having a bad day or what.

Bec

here's the .svg - your message went to my junk mail, you may want to check for my message in your junk mail...

Thanks to all who helped me with this file. I have another question. There is a thin outer line on this and I need it to remain on there. When I cut this (which is a small image about 3") it won't cut the outer line. Is this because the image I'm cutting is too small?

Thanks!

It might be because the svg file had a Group and SCAL1 does not like groups. I ungrouped it and thickened the inner and outer ring a little. Hopefully that wasn't too big of a change for them. HTH

Thanks Heather. That works much better. I think I need to take the time to figure out how to do some of these modifications. Again thanks it looks great.