Craft Edge

Sure Cuts A Lot Forum
It is currently Sat Sep 23, 2017 3:38 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Tue Apr 07, 2015 1:30 pm 

Joined: Tue Apr 07, 2015 1:23 pm
Posts: 3
I am very new to all of this vinyl cutting experience so please bear with me. I created a graphic in MS paint and saved it as a .png I then loaded that into Inkscape and created a decal with an oval border around it. I then utilized the SCAL extension. This worked OK in that it ran SCAL with the decal shown. The problem comes in when I try to cut the decal. If I look at preview, it looks fine. When I go to the 'Cut' screen, the graphic is missing. The oval is shown but the graphic is not there. I even tried cutting thinking maybe it would cut OK since preview looked OK but all it cut was the oval and not the graphic. Any ideas or suggestions? I thought I would try to create the same decal in SCAL but could not load the graphic since it was in a format other than .scal I'm stumped!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group