Craft Edge

Sure Cuts A Lot Forum
It is currently Fri Jul 28, 2017 3:00 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: svg import problem
PostPosted: Sat Feb 21, 2015 4:34 am 

Joined: Sat Feb 21, 2015 4:32 am
Posts: 1
Might be a simple question, but.

I'm using sure cuts 3 and whenever I import an svg from Illustrator it will almost always cut the image twice (on top of another). I can use trace image in sure cuts a lot and it's fine, but any time I import an svg it's doing it twice, it's driving me nuts. I've been using the pen tool to try and trouble shoot.

I like importing an svg because I like to tweek the image in Illustrator. I've attached two pictures and they might me hard to tell, but you can notice the svg import (top) is much darker since it did two passes.


Attachments:
2pass.jpg
2pass.jpg [ 28.92 KiB | Viewed 1623 times ]
1pass.jpg
1pass.jpg [ 27.03 KiB | Viewed 1623 times ]
Top
 Profile  
 
 Post subject: Re: svg import problem
PostPosted: Sat Feb 21, 2015 6:52 am 

Joined: Sun Jan 11, 2009 7:16 am
Posts: 3907
Location: Michigan, SCAL1; SCAL2; eCAL; Windows7 64 bit; eCAL Mavericks
Are you using both a stroke and a fill? A quirk of AI is that it creates separate Paths for Stroke and Fill when saving as svg. Try using one or the other. HTH

_________________
My blog


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group