Craft Edge

Just got a Cameo
Page 1 of 1

Author:  jasenj1 [ Wed Jan 25, 2012 7:16 pm ]
Post subject:  Just got a Cameo

:D :D My new Cameo arrived tonight!

I wasn't very impressed with the "out of the box" experience. The manual is not very good at walking you through getting the machine set up. But once I got it cutting, it cuts!

I used SCAL 3 with it. When I tried to use "Test Cut" in SCAL 3, it crashed. :(

I haven't had a chance to do any print & cut with it yet - the reason I bought it. I plan to get to that tomorrow.

Hooray for new toys!

- Jasen.

Author:  DogCarbon [ Thu Jan 26, 2012 3:48 am ]
Post subject:  Re: Just got a Cameo

HURRAY for YOU! I so remember your frustation with the E and trying to do PnC.

I too have ordered a Cameo, it should arrive tomorrow!

Maybe we can work together to get them up and running!

Author:  jasenj1 [ Thu Jan 26, 2012 8:29 am ]
Post subject:  Re: Just got a Cameo

Up and running. Getting it going wasn't too bad, but for a complete newbie it could be frustrating. Not enough EXTREMELY clear hand-holding on how to install the blade. The instructions are basically, "make sure the blade is in all the way".

Anyway. Here's my first PnC. I used the same SVG file I had made before for use on the Cricut. Template cut perfectly using registration marks. Hooray!

- Jasen.

Pink Rommy with Cameo.jpg
Pink Rommy with Cameo.jpg [ 132.82 KiB | Viewed 6060 times ]

Author:  gj1 [ Thu Jan 26, 2012 9:06 am ]
Post subject:  Re: Just got a Cameo

So glad for you...and the are going to have some fun and less frustration...please continue to show your projects. I love to look at them.

Author:  DogCarbon [ Thu Jan 26, 2012 9:16 am ]
Post subject:  Re: Just got a Cameo

very nice PnC Jasen!

Author:  Deloris [ Thu Jan 26, 2012 3:04 pm ]
Post subject:  Re: Just got a Cameo

Check out this forum for Cameo users:

Lots of experienced users there that can answer your questions about how to do things with the Cameo and free cutting files.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group