Craft Edge
http://forum.surecutsalot.com/

SCAL for eCraft machines
http://forum.surecutsalot.com/viewtopic.php?f=11&t=18338
Page 1 of 4

Author:  craftedge [ Thu Feb 03, 2011 3:37 pm ]
Post subject:  SCAL for eCraft machines

We have a version of SCAL to work with the eCraft in beta testing right now.
If you are interesting in helping to test out the new version, please email us at
betatest@craftedge.com

and indicate your operating system and what firmware version is on your eCraft (version shown on the display on the eCraft right after you turn it on)

Author:  scrpbooklady [ Thu Feb 03, 2011 4:10 pm ]
Post subject:  Re: SCAL for eCraft machines

Wish I had one - but I've been delaying any purchase decision until SCAL was compatible! I'll be watching for updates on this!

Author:  Butterfly [ Thu Feb 03, 2011 9:20 pm ]
Post subject:  Re: SCAL for eCraft machines

Me too

Kiss PC good bye

Author:  richardcnc [ Fri Feb 04, 2011 4:27 am ]
Post subject:  Re: SCAL for eCraft machines

I have an ecraft and am looking forward to testing the beta version, I have sent an email.

Author:  He**inwa [ Sat Mar 12, 2011 4:17 pm ]
Post subject:  Re: SCAL for eCraft machines

Quote:
Me too

Kiss PC good bye


^ ^ ^
That.
Particularly after the last few days.

And no mats!
JMO

Author:  imcindyc [ Tue Mar 15, 2011 10:25 am ]
Post subject:  Re: SCAL for eCraft machines

Do we have an ETA of when SCAL will be available to use with the eCraft?

Author:  pennsylvaniakate [ Wed Mar 16, 2011 11:05 am ]
Post subject:  Re: SCAL for eCraft machines

If you already have an Ecraft, you can contact Craft Edge about testing the Beta version.

Author:  Amanda_Nicole0315 [ Mon Apr 11, 2011 12:46 pm ]
Post subject:  Re: SCAL for eCraft machines

ECRAFT the best easy to use and i save a lot on money all i need to buy is paper and nothing else. Fast and easy.

Author:  renees [ Tue Apr 12, 2011 11:51 am ]
Post subject:  Re: SCAL for eCraft machines

I downloaded a trial version that allows the ecraft to work with SCAL but it cuts the lines through the project and does the whole purchase thing. So are we going to have to buy a new license to use SCAL on the Ecraft or just update the license we have now? If we have to purchase another copy of SCAL then when would be a good time to do that?
ReneeS

Author:  pennsylvaniakate [ Wed Apr 13, 2011 8:06 am ]
Post subject:  Re: SCAL for eCraft machines

If you contacted Craft Edge, and they sent you the Beta version to test, you should not have the watermark cuts or be prompted to purchase. You are helping them in testing the software to find improvements for a future release and need to be able to use the complete Beta version.

Page 1 of 4 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/