Craft Edge

Hello, It's been a while, but I am still dealing with the same problem. To review: -craftwell ecraft, machine works fine. -SCAL5, registered -some path with a good number of nodes When I assign a solid line to the path, it cuts fine, sometimes continuously and sometimes in little chirps but accurate...

Sandy, did you ever get my resent file? I sent it to both emails.
Thanks!

Ooops, just saw this. I'll resend to both.

Hi Sandy,

I did send you a file this weekend. Let me know if you didn't get it. Thanks!

Arg... submitted before done. I dug this out again and haven't found an answer. I did upgrade to SCAL5. Pix attached. craftwell ecraft with firmware 2.0 I've fooled around with resolution, node simplification, and anything else that looked promising, but to no avail. I am going to try manual stencil...

Hello,

I dug this out again... still no solution. I also purchased scal5, and same results.

Attached are some pix:

Update: I did some more tests, with the following results: -If I leave the lines as continuous, it seems to be fine. -If I change any of the cuts to dashed lines, it seems to insert a bunch of garbage, which seems to be consistent with "watermarking". In particular, it seems to put the tab...

Hello, Newbie here, I couldn't find any answer elsewhere here. I am cutting some curved shapes out of basically card stock with SCUT3 and an eCraft cutter, and I am having trouble with "tabs" as eCraft calls them, or "gaps" in the lines as they seem to be referred to in SCUT. Mor...