Craft Edge

Here is another one that I used a font to replace the text. You can use the simplify in SCAL2, but a threshold of about 25 was as high as I could go without distorting the text. That reduced the new file to just over 500 nodes. You will probably need to clean it up node by node to get the best resu...

DogCarbon wrote:you can simplify in inkscape, but you need to reduce a setting.

Go to File/ Inkscape preferences/ Misc (at the bottom) and then under Simplification Threshold, reduce that to as low as 0.0001 (I like to use somewhere between 2 and 6)

thanks for helping!!!

I did simplify and it made it look awful!

Okay..here I am again..needing help with this logo. I have to make 130 of these logos. I fit 4 on my 12x24 mat and it literally took like 20 minutes to cut them out. I pulled it into inkscape and did a "simplify" on it and it distorted it pretty bad. Anyone know how I can get this to cut f...

Thank u so much Joanne!!

Actually Heather, I do have one more request. Is there anyway you could make it where each letter in JROTC is indidvidual and not touching the ones next to them? Thank you so much!!!

Heather thank u soooo much!!!! You have made life much easier for me! I have to make 130 of these for vinyl decals. You are a lifesaver! And sandy thank u so much for trying!!

Hello! I havent been to this forum in a LONG time!! had a baby girl and got into making hairbows and my cricut collected some dust. BUT here I am again and need some help and I knew this would be the best place to come...I have a logo I have to make 130 of. Its the Army JROTC logo. I have it but whe...

The link from Grammy for the handbooks says it's not valid on 4 shared. Im guessing it got deleted? Anyone have any that are still working or any pdf's they wanna send to me? THANKKKKSSSS!!!

When I convert my image into a SVG and import it into SCAL2, it doesnt look the same as in INK. It gets distorted and the some lines are farther from each other than before. What am I doing wrong!? TIA!!